How do you remove slate tile floor from a wood sub-base?
April 13, 2009
In the beginning, the tile came up very nice…..then with about an area 1'X4' (by the front door) the tile is breaking and the glue is holding it in place. Will a heat gun work to get the rest or is there a better way??? I am preparing to have hardwood floors installed.
Posted in Slate Floor Tile
content rss
April 13th, 2009 at 5:51 pm
hammer and chisel would be the most time consuming way with lots of elbow grease, but wouldn't cost any money if you already own both. consider renting a chipping hammer from a tool rental place by the hour if available, or for half a day as a maximum. it'll come up in 15-20 minutes with the chipping hammer and shouldn't cost more than $50 for the half day's rental (should be cheaper i would think). do protect windows nearby and such and wear safety glasses. use the flat chisel attachment and start at the edge of the tile to be removed. go at a 45 degree angle or so and just push the chipping hammer under the tiles. don't force it, the chipping hammer will do all the work rather nicely. good luck!
April 13th, 2009 at 5:51 pm
try that or u can get a coal chisel and chip it out…..
lic. gen. contractor
April 13th, 2009 at 5:51 pm
You need to get a chisel tap it out with a hammer. Ive done it before. Make sure you put up protectors so that tile does not hit your wall/glass/doors. The tile does fly when your hitting it
April 13th, 2009 at 5:51 pm
If I were doing the job, since it is a small area, I would cut the plywood with a skill saw (set at the propper depth), remove it and the replace it making sure to thoroughly glue and nail it down. Wood will flex while tile and linoleum will crack or crease. Even if you are not a "pro", time is money and wood flooring will hide any sins you might make.